Manpages - atmloop.8

atmloop - get/set loopback mode of ATM interfaces

atmloop -s [*-l /level/*] [*-r /level/*] [*/itf/*]
atmloop [*/itf/*]
atmloop -q [*/itf/*]
atmloop -V

atmloop sets or shows the current loopback settings of an ATM interface, and allows to query the loopback modes supported by the interface.

Some ATM cards can be configured to echo data back to the driver (local loopback) or to the network (remote loopback). The echoing may be done at several different levels:

aal

AAL PDUs

atm

ATM cells

digital

bits sent to or received from the line interface

analog

the analog signal

The levels supported by an interface can be queried with the -q option. If invoked without options, atmloop displays the current loopback settings.

-s

set loopback mode. Followed by either -l or -r, both options to set local and remote loopback at the same time (if supported by the driver), or none of them to turn off any loopback.

-l level

enable local loopback.

-r level

enable remote loopback.

-q level

query loopback levels supported by the interface.

-V

print version number of atmloop on standard output and exit.

Werner Almesberger, EPFL ICA <Werner.Almesberger@epfl.ch>

atmdiag(8), sonetdiag(8)