Manpages - atmarp.8

atmarp - administer classical IP over ATM connections

atmarp -a
atmarp -c [[atm]/number/]
atmarp -q ip_addr [*qos qos/*] [*sndbuf /bytes/*]
atmarp -s /ip_addr [/itf/.]/vpi/./vci/ [*qos /qos/*] [*sndbuf bytes/*] [*temp*] [*pub*] [*null*]
atmarp -s /ip_addr atm_addr [*qos /qos/*] [*sndbuf /bytes/*] [*temp*] [*pub*] [*arpsrv*]
atmarp -d ip_addr [*arpsrv*]
atmarp -V

atmarp is used to maintain the ATMARP table of the ATMARP demon. The table can be listed, new PVC and SVC entries can be added, and existing entries can be deleted. In addition to that, atmarp is also used to create new IP over ATM interfaces.

Note that the kernel has its own ATMARP table containing only entries for destinations to which a connection exists. The table of atmarpd can also contain currently unused entries.

-a

list the current ATMARP table.

-c

create the specified IP interface. If the interface number is omitted, the operating system assigns the next free number and atmarp prints the resulting interface name (e.g. `atm0’) on standard output.

-q

sets the QOS and the send buffer size to use as the default for all VCs generated for that IP network (ip_addr must be the address of the network).

-s

set up a PVC or create an SVC entry. The following options are recognized:

qos qos

uses the specified quality of service (see qos(7) for the syntax). UBR at link speed is used by default.

sndbuf bytes

tries to set the send buffer to the specified number of bytes. A system default value is used if sndbuf is not specified.

temp

does not mark the entry as permanent, i.e. it will time out and then be removed.

pub

publishes the entry (only relevant for ATMARP server). ATMARP requests for entries not marked for publishing yield an ATMARP_NAK response.

null

uses NULL encapsulation instead of LLC/SNAP encapsulation on the PVC. This option is not available for SVCs, because the LLC/SNAP header is required to identify ATMARP packets. null also implies that the entry is permanent.

arpsrv

identifies the entry pointing to the ATMARP server. Note that the node acting as the ATMARP server must have no ATMARP server entry in its ATMARP table.

-d

delete the specified ARP entry. In order to prevent accidental deletion of the ATMARP server entry, the arpsrv flag must be specified when deleting it.

-V

print the version number of atmarp on standard output and exit.

/var/run/atmarpd.table

ATMARP table

Werner Almesberger, EPFL ICA <Werner.Almesberger@epfl.ch>

atmarpd(8), clip(8), qos(7)