Manpages - s390_runtime_instr.2

s390_runtime_instr - enable/disable s390 CPU run-time instrumentation

  #include <asm/runtime_instr.h> /* Definition of S390_* constants */
  #include <sys/syscall.h> /* Definition of SYS_* constants */
  #include <unistd.h>

  int syscall(SYS_s390_runtime_instr, int command, int signum);

Note: glibc provides no wrapper for *s390_runtime_instr*(), necessitating the use of *syscall*(2).

The *s390_runtime_instr*() system call starts or stops CPU run-time instrumentation for the calling thread.

The command argument controls whether run-time instrumentation is started (S390_RUNTIME_INSTR_START, 1) or stopped (S390_RUNTIME_INSTR_STOP, 2) for the calling thread.

The signum argument specifies the number of a real-time signal. This argument was used to specify a signal number that should be delivered to the thread if the run-time instrumentation buffer was full or if the run-time-instrumentation-halted interrupt had occurred. This feature was never used, and in Linux 4.4 support for this feature was removed; thus, in current kernels, this argument is ignored.

On success, *s390_runtime_instr*() returns 0 and enables the thread for run-time instrumentation by assigning the thread a default run-time instrumentation control block. The caller can then read and modify the control block and start the run-time instrumentation. On error, -1 is returned and errno is set to indicate the error.

EINVAL

The value specified in command is not a valid command.

EINVAL

The value specified in signum is not a real-time signal number. From Linux 4.4 onwards, the signum argument has no effect, so that an invalid signal number will not result in an error.

ENOMEM

Allocating memory for the run-time instrumentation control block failed.

EOPNOTSUPP

The run-time instrumentation facility is not available.

This system call is available since Linux 3.7.

This Linux-specific system call is available only on the s390 architecture. The run-time instrumentation facility is available beginning with System z EC12.

The asm/runtime_instr.h header file is available since Linux 4.16.

Starting with Linux 4.4, support for signalling was removed, as was the check whether signum is a valid real-time signal. For backwards compatibility with older kernels, it is recommended to pass a valid real-time signal number in signum and install a handler for that signal.

*syscall*(2), *signal*(7)

This page is part of release 5.13 of the Linux man-pages project. A description of the project, information about reporting bugs, and the latest version of this page, can be found at https://www.kernel.org/doc/man-pages/.