Man1 - mshortname.1

mshortname - shows short name of a file

This manpage has been automatically generated from mtools’s texinfo documentation, and may not be entirely accurate or complete. See the end of this man page for details.

The mshortname command is used to display the short name of a file. Syntax:

  mshortname files

The shortname is displayed as it is stored in raw format on disk, without any character set conversion.

Mtools’ texinfo doc

This manpage has been automatically generated from mtools’s texinfo documentation. However, this process is only approximative, and some items, such as crossreferences, footnotes and indices are lost in this translation process. Indeed, these items have no appropriate representation in the manpage format. Moreover, not all information has been translated into the manpage version. Thus I strongly advise you to use the original texinfo doc. See the end of this manpage for instructions how to view the texinfo doc.

*

To generate a printable copy from the texinfo doc, run the following commands:

      ./configure; make dvi; dvips mtools.dvi

*

To generate a html copy, run:

      ./configure; make html

A premade html can be found at ∞http://www.gnu.org/software/mtools/manual/mtools.html∫

*

To generate an info copy (browsable using emacs’ info mode), run:

      ./configure; make info

The texinfo doc looks most pretty when printed or as html. Indeed, in the info version certain examples are difficult to read due to the quoting conventions used in info.